Wahuda 6-Inch Jointer
After taking in over 4 years of suggestions, ideas and
concerns, from our valued customers, we listened and upped our game!
Following on the success of our previous 6 inch jointer
models, we'd like to introduce our newly upgraded 6 " WAHUDA spiral style bench
top jointer model 50160CC-WHD.
Still geared towards the budget-minded novice, but very
capable of milling stock in a small pro shop, it's manufactured to tight
tolerances in a certified ISO 9001 factory and is CSA approved for performance
and your safety.
Sporting new cast iron tables, our new 6" jointer only weighs
about 48 lbs making it still easily maneuvered around your shop or jobsite. The
cast iron tables also provide better stability during operation and are less
prone to scratching. Table leveling for coplanar, if ever needed, is still
easily achieved via set screws installed in each table. With the 30 inch
total table length end to end, and a total depth of just over 17 inches and
total height of just over 13 inches, it fits in the smallest of available shop
With the included new spiral style cutterhead, manufactured
with the same heavy duty aluminum extrusion over steel inner shaft, you now get
the cutting edge sharpness retention from having 12 carbide 4-sided insert tips
installed. While being quieter than the straight knife cutterhead noise you
have had to endure, you also get the smooth finish on your stock you've been
looking for from the spiral design ... even on figured woods. Only having to loosen or remove one mounting
screw on each insert, provides extremely quick tip rotation or replacement if
the insert becomes nicked, keeping your downtime to a minimum and your project
Our new 6 " jointer has some of the same features as our
previous highly touted models.
It still has the
maximum capacity of 6" width and 1/8" maximum depth of cut,
a 2½" included dust port for better chip evacuation,
and 4 3/8" high by 19 5/8"
aluminum fence which can be easily tilted from 90 to 135 degrees with ease. It
has the same 120V 10 amp AC motor which provides ample power requirements.
Included are the push blocks, the tools you need to properly set up and adjust
the machine, and a T-Torx wrench to rotate or replace the insert tips.
If our 6" jointer does not have the width or length
capacity you are looking for, check out our 8" jointer model 50180CC-WHD or our 50110CC-WHD 10" bench top jointer.
Warranty on this jointer is 2 years and the specifics of the warranty can be found on page 3 of the manual. Link to the manual is below...
Need the machine dimensions to make a bench or table for this jointer? 50160CC-WHD Dimensions
CLICK HERE TO SEE THE MANUAL